Pni Legacy Comm Board Manuel d'utilisateur télécharger pdf (Page 9)

PNI Corporation 133 Aviation Blvd., Suite 101, Santa Rosa, CA 95403-1084 USA;, Fax: (707) 566-2261

For the most current specifications, please visit our website at: www.pnicorp.com

Page 9 of 42

Raw Output Mode (sdo=r)

The Raw Output mode allows for the output of the raw, uncorrected data for any or all of the

required sensors. The Raw Output Mode is the only mode where Z-Axis is active.

EXAMPLE:

$raw,X53Y-420Z0*6E

$raw,{data}*<dcs><es>

Table 10: Raw Output Modes

$ Start data delimiter

{data} Selected data output

* End data delimiter

<dcs> Checksum

<es> End of message based on eol variable <cr> or <lf> or <cr><lf>

NOTE: For modules with a Z-axis when used in other modes than raw, Z-axis is turned off and module

is run as a Z-axis system since no tilt compensation is being done.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 41 42

Pas de commentaire

Pni Legacy Comm Board Manuel d'utilisateur Page 9